1-8 of 8
Keywords: yield strength
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Tribol. July 2007, 129(3): 536–543.
Published Online: December 6, 2006
.... The results demonstrate that the maximum surface equivalent stress may exceed the material yield strength during an emergency braking, which may cause a plastic damage accumulation in a brake disk, while a residual tensile hoop stress is incurred on cooling. These results are validated by experimental...
Journal Articles
Publisher: ASME
Article Type: Article
J. Tribol. April 2005, 127(2): 343–354.
Published Online: April 7, 2005
... and Firestone) and the perfectly elastic case (known as the Hertz contact). This work finds that the fully plastic average contact pressure, or hardness, commonly approximated to be a constant factor of about three times the yield strength, actually varies with the deformed contact geometry, which in turn...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Tribol. January 2004, 126(1): 71–80.
Published Online: January 13, 2004
..., and surface speed. Using the FEM, a parametric study demonstrated that material properties (i.e., modulus of elasticity, yield strength, ultimate strength and Poisson’s ratio) and friction coefficients play significant roles on the height and width of dents on the mating surfaces. For lower friction...
Journal Articles
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Tribol. October 2003, 125(4): 692–699.
Published Online: September 25, 2003
.... Adams. 10 July 2002 11 December 2002 25 09 2003 internal stresses elastoplasticity indentation sliding friction finite element analysis plastic deformation cracks crack-edge stress field analysis wear yield strength mechanical contact Surface residual stresses...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Tribol. January 2002, 124(1): 103–108.
Published Online: June 26, 2001
... von Mises’ stress should be equal to the yield strength of the disc. This provides an accurate, quantitative check on the theoretical values. Contributed by the Tribology Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for presentation at the STLE/ASME Tribology Conference, San...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Tribol. October 2001, 123(4): 676–681.
Published Online: October 20, 2000
... analysis indicated a potential relationship between wear rate and a combination of yield strength, solidus temperature and post-wear inverse hardness. Batchelor , A. W. , and Stachowiak , G. W. , 1992 , “ Extending the Life of Wire Ropes by the Development of Improved Wire Coatings...