The feasibility of using a rotating heat pipe to anti-ice the nose cones of small turbofan aero-engines is investigated. A stationary jacket evaporator design was used to transport heat into the rotating heat pipe located along the central fan shaft of the engine. The rotating heat pipe condenser was made an integral part of the nose cone using a high conductivity, lightweight material and the tip of the nose cone. The use of heating channels along the nose cone and passive heat transfer enhancement in the evaporator were also investigated. The computational model used to predict the heat transfer performance is outlined. The overall heat transfer to the nose cone was 0.8–1.2 kW using water in the heat pipe and 0.4–0.75kW using ethanol. The heating channels were not effective due to the small contact area with the nose cone. The heat transfer enhancement in the evaporator increased the total heat transfer modestly and the temperature of the nose cone increased over the contact area made with the high conductivity material. The results show that rotating heat pipes are a feasible nose cone anti-icing technology.
Skip Nav Destination
e-mail: chingcy@mcmaster.ca
Article navigation
June 2009
Invited Papers
On the Design of an Aero-Engine Nose Cone Anti-Icing System Using a Rotating Heat Pipe
S. Gilchrist,
S. Gilchrist
Department of Mechanical Engineering,
McMaster University
, Hamilton, ON, L8S4L7, Canada
Search for other works by this author on:
D. Ewing,
D. Ewing
Department of Mechanical Engineering,
McMaster University
, Hamilton, ON, L8S4L7, Canada
Search for other works by this author on:
C. Y. Ching
C. Y. Ching
Department of Mechanical Engineering,
e-mail: chingcy@mcmaster.ca
McMaster University
, Hamilton, ON, L8S4L7, Canada
Search for other works by this author on:
S. Gilchrist
Department of Mechanical Engineering,
McMaster University
, Hamilton, ON, L8S4L7, Canada
D. Ewing
Department of Mechanical Engineering,
McMaster University
, Hamilton, ON, L8S4L7, Canada
C. Y. Ching
Department of Mechanical Engineering,
McMaster University
, Hamilton, ON, L8S4L7, Canadae-mail: chingcy@mcmaster.ca
J. Thermal Sci. Eng. Appl. Jun 2009, 1(2): 022002 (11 pages)
Published Online: October 13, 2009
Article history
Received:
February 27, 2009
Revised:
September 1, 2009
Published:
October 13, 2009
Citation
Gilchrist, S., Ewing, D., and Ching, C. Y. (October 13, 2009). "On the Design of an Aero-Engine Nose Cone Anti-Icing System Using a Rotating Heat Pipe." ASME. J. Thermal Sci. Eng. Appl. June 2009; 1(2): 022002. https://doi.org/10.1115/1.4000191
Download citation file:
Get Email Alerts
Cited By
Investigation on the Influence of Rural Residents' Behavior Regulation on Gas-Fired Combi-Boiler Heating in Northern China
J. Thermal Sci. Eng. Appl (February 2025)
Simulation and Experimental Study of Two-Phase Gas–Liquid Behavior in Two-Dimensional Porous Medium Based on Lattice Boltzmann Method
J. Thermal Sci. Eng. Appl (February 2025)
Effect of Variation of the Aspect Ratio of Rectangular Twisted Tapes Inserted in a Circular Pipe on the Thermal Performance
J. Thermal Sci. Eng. Appl (February 2025)
Energy-Efficient Three-Wheel Bleedless Electrical Environmental Control System for a Passenger Aircraft
J. Thermal Sci. Eng. Appl (February 2025)
Related Articles
Heat Transfer Characteristics of Oscillating Heat Pipe With Water and Ethanol as Working Fluids
J. Heat Transfer (December,2010)
Utilization of Advanced Working Fluids With Biporous Evaporators
J. Thermal Sci. Eng. Appl (June,2011)
A Comprehensive Experimental Investigation of the Performance of Closed-Loop Pulsating Heat Pipes
J. Heat Transfer (September,2017)
Nonlinear Analysis of Chaotic Flow in a Three-Dimensional Closed-Loop Pulsating Heat Pipe
J. Heat Transfer (December,2016)
Related Proceedings Papers
Related Chapters
Lay-Up and Start-Up Practices
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
The Special Characteristics of Closed-Cycle Gas Turbines
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Threshold Functions
Closed-Cycle Gas Turbines: Operating Experience and Future Potential