Abstract

The present study used a novel double-wire pulsed gas metal arc welding (GMAW) method, enhanced with high-frequency pulses, for welding aluminum (Al) alloy. A digital oscilloscope and high-speed photography were used to capture the voltage and current waveforms at various phases and high-frequency pulse frequencies, along with the corresponding double arc profiles. The influence mechanism of high-frequency pulse frequency on the arc average current density and arc conductivity was combined to investigate the effects of phase and high-frequency pulse frequency on arc characteristics. The experimental results revealed that arc voltage, arc power, and arc length initially decreased and then increased as the high-frequency pulse frequency rose. The phase had a significant impact on the deflection angle of the arc. The reverse phase exhibited a smaller peak deflection angle compared to the synchronous phase due to the different ratios of leading and trailing currents. However, the deflection angle of the arc remained relatively unaffected by the high-frequency pulse frequency.

References

1.
Sproesser
,
G.
,
Chang
,
Y. J.
,
Pittner
,
A.
,
Finkbeiner
,
M.
, and
Rethmeier
,
M.
,
2017
, “
Energy Efficiency and Environmental Impacts of High Power Gas Metal Arc Welding
,”
Int. J. Adv. Manuf. Technol.
,
91
(
9–12
), pp.
3503
3513
.
2.
Ueyama
,
T.
,
Uezono
,
T.
,
Era
,
T.
,
Tanaka
,
M.
, and
Nakata
,
K.
,
2009
, “
Solution to Problems of Arc Interruption and Arc Length Control in Tandem Pulsed Gas Metal Arc Welding
,”
Sci. Technol. Weld. Join.
,
14
(
4
), pp.
305
314
.
3.
Ye
,
D. J.
,
Hua
,
X. M.
,
Xu
,
C.
,
Li
,
F.
, and
Wu
,
Y. X.
,
2017
, “
Research on Arc Interference and Welding Operating Point Change of Twin Wire MIG Welding
,”
Int. J. Adv. Manuf. Technol.
,
89
(
1–4
), pp.
493
502
.
4.
Wu
,
K. Y.
,
Wang
,
J. J.
,
Yin
,
T.
,
He
,
Z. W.
, and
Liang
,
Z. Y.
,
2018
, “
Double Arc Interference and Dynamic Behavior Characteristics of Double Wire Double-Pulsed GMAW
,”
Int. J. Adv. Manuf. Technol.
,
95
(
1-4
), pp.
991
1002
.
5.
Wu
,
K. Y.
,
Xie
,
P. M.
,
Liu
,
Z.
,
Zeng
,
M.
, and
Liang
,
Z. Y.
,
2020
, “
Investigation of Double Arc Interaction Mechanism and Quantitative Analysis of Double Arc Offset in High-Power Double-Wire DP-GMAW
,”
J. Manuf. Process.
,
49
, pp.
423
437
.
6.
Ueyama
,
T.
,
Ohnawa
,
T.
,
Tanaka
,
M.
, and
Nakata
,
K.
,
2007
, “
Occurrence of Arc Interaction in Tandem Pulsed Gas Metal Arc Welding
,”
Sci. Technol. Weld. Join.
,
12
(
6
), pp.
523
529
.
7.
Pablo Reis
,
R.
,
Souza
,
D.
, and
Ferreira
,
D.
,
2014
, “
Arc Interruptions in Tandem Pulsed Gas Metal Arc Welding
,”
ASME J. Manuf. Sci. Eng.
,
137
(
1
), p.
011004
.
8.
Chen
,
D. S.
,
Chen
,
M. A.
, and
Wu
,
C. S.
,
2015
, “
Effects of Phase Difference on the Behavior of Arc and Weld Pool in Tandem P-GMAW
,”
J. Mater. Process. Technol.
,
225
, pp.
45
55
.
9.
Wu
,
K. Y.
,
He
,
Z. W.
,
Liang
,
Z. Y.
, and
Cheng
,
J.
,
2016
, “
The Dynamic Behavior of Double Arc Interference in High-Power Double Wire Pulsed GMAW
,”
Int. J. Adv. Manuf. Technol.
,
88
(
9–12
), pp.
2795
2802
.
10.
Wu
,
K. Y.
,
Wang
,
Y. F.
,
Tao
,
T. Y.
,
Zhan
,
J. T.
, and
Hong
,
X. B.
,
2022
, “
Effect of Phase Shift on Arc Interference and Weld Bead Formation in Aluminum Alloy Tandem GMAW With a Median Pulsed Waveform
,”
Int. J. Adv. Manuf. Technol.
,
120
(
11–12
), pp.
8013
8030
.
11.
Wang
,
Z. M.
,
Jiang
,
D. H.
,
Wu
,
J. W.
, and
Xu
,
M. J.
,
2020
, “
A Review on High-Frequency Pulsed Arc Welding
,”
J. Manuf. Process.
,
60
, pp.
503
519
.
12.
Yang
,
M. X.
,
Zheng
,
H.
,
Qi
,
B. J.
, and
Yang
,
Z.
,
2017
, “
Effect of Arc Behavior on Ti-6Al-4 V Welds During High Frequency Pulsed Arc Welding
,”
J. Mater. Process. Technol.
,
243
, pp.
9
15
.
13.
Yang
,
M. X.
,
Li
,
L.
,
Qi
,
B. J.
, and
Zheng
,
H.
,
2017
, “
Arc Force and Shapes With High-Frequency Pulsed-Arc Welding
,”
Sci. Technol. Weld. Join.
,
22
(
7
), pp.
580
586
.
14.
Qi
,
B. J.
,
Yang
,
M. X.
,
Cong
,
B. Q.
, and
Liu
,
F. J.
,
2013
, “
The Effect of Arc Behavior on Weld Geometry by High-Frequency Pulse GTAW Process With 0Cr18Ni9Ti Stainless Steel
,”
Int. J. Adv. Manuf. Technol.
,
66
(
9-12
), pp.
1545
1553
.
15.
Li
,
W.
,
Lv
,
G. C.
,
Wang
,
Q.
, and
Huang
,
S. T.
,
2020
, “
Arc Characteristics and Weld Bead Microstructure of Ti-6Al-4V Titanium Alloy in Ultra-High Frequency Pulse Gas Tungsten Arc Welding (UHFP-GTAW) Process
,”
Mater. Sci-Medzg.
,
26
(
4
), pp.
426
431
.
16.
Liu
,
H.
,
Qi
,
B. J.
,
Qi
,
Z. W.
,
Zhu
,
Y.
,
Guo
,
W.
,
Yang
,
M. X.
, and
Mendez
,
P. F.
,
2023
, “
Mechanism of Constriction in a High Frequency Pulsed Welding Arc
,”
Int. J. Heat. Mass. Transf.
,
211
, p.
124251
.
17.
Chen
,
S. J.
,
Zhang
,
J. Z.
,
Zhao
,
H. Y.
,
Yu
,
Y.
,
Zhang
,
G. K.
, and
Lv
,
T.
,
2024
, “
Development of Ultra-High Frequency Adjustable Multi-Pulsed Gas Tungsten Arc Welding Power Supply and Analysis of Arc Morphology
,”
J. Manuf. Process.
,
125
, pp.
295
305
.
18.
Wu
,
J. W.
,
Xu
,
M. J.
,
Lin
,
S. B.
,
Zhang
,
Q.
,
Wu
,
X. M.
,
Tian
,
J. Y.
, and
Wang
,
Z. M.
,
2023
, “
Refining Microstructures and Enhancing Mechanical Properties of Inconel 718 Weldment via Fast-Frequency Double Pulsed Waveforms Adopting in FFP-TIG
,”
J. Mater. Process. Technol.
,
314
, p.
117882
.
19.
Yang
,
M. X.
,
Yang
,
Z.
,
Cong
,
B. Q.
, and
Qi
,
B. J.
,
2015
, “
How Ultra High Frequency of Pulsed Gas Tungsten Arc Welding Affects Weld Porosity of Ti-6Al-4 V Alloy
,”
Int. J. Adv. Manuf. Technol.
,
76
(
5–8
), pp.
955
960
.
20.
Wang
,
Y. J.
,
Chen
,
M. A.
, and
Wu
,
C. S.
,
2020
, “
High-Frequency Pulse-Modulated Square Wave AC TIG Welding of AA6061-T6 Aluminum Alloy
,”
Weld. World.
,
64
(
10
), pp.
1749
1762
.
21.
Zheng
,
H.
,
Qi
,
B. J.
, and
Yang
,
M. X.
,
2021
, “
Dynamic Analysis of the Ultrasonic-Frequency Pulsed GMAW Metal Transfer Process
,”
J. Manuf. Process.
,
62
, pp.
283
290
.
22.
Zhao
,
J. R.
,
Sun
,
D.
,
Hu
,
S. S.
, and
Zhang
,
X. M.
,
1992
, “
Anode Behavior of High Frequency Pulse TIG Welding Arc
,”
Trans. China. Weld. Inst.
,
13
(
1
), pp.
59
66
. http://hjxb.hwi.com.cn/hjxb/en/article/id/19920110
23.
Zhang
,
H.
,
He
,
J. P.
,
Tang
,
L. L.
, and
Zhang
,
J. N.
,
2019
, “
High Frequency Characters of Arc Light Radiation in Micro Plasma Arc Welding with Pulsed Current
,”
Results. Phys.
,
13
, p.
102259
.
24.
Chen
,
S. J.
,
Wang
,
L. W.
,
Wei
,
P. S.
,
Xiao
,
J.
,
Jia
,
Y. Z.
, and
Su
,
S.
,
2016
, “
Sustaining the Inter-Wire Arc in Twin-Wire Indirect Arc Welding
,”
J. Manuf. Process.
,
21
, pp.
69
74
.
25.
Wang
,
D. L.
,
Wu
,
C. F.
,
Suo
,
Y. C.
,
Wang
,
L. W.
, and
Liang
,
Z. M.
,
2019
, “
Effect of Pulse Frequency on Arc Behavior and Droplet Transfer of 2198 Al-Li Alloy by Ultrahigh-Frequency Pulse AC CMT Welding
,”
J. Mater. Res. Technol-JMRT.
,
8
(
5
), pp.
3950
3958
.
You do not currently have access to this content.