Abstract

This article treats the local heat transfer for nucleate pool boiling around the cylinder using the inverse heat conduction analysis. The physical model considers a half section of a cylinder with unknown surface temperature and heat flux density. The iterative regularization and the conjugate gradient methods are used for solving the inverse analysis. The local Nusselt number profiles for nucleate pool boiling are presented and analyzed for different electric heat. The mean Nusselt number estimated by IHCP is closed with the measured values. The results of IHCP are compared to those of Cornewell and Houston (1994), Stephan and Abdelsalam (1980) and Memory et al. (1995). The influence of the error of the measured temperatures and the error in placement of the thermocouples are studied.

1.
Thome, J. R., 1990, Enhanced Boiling Heat Transfer, Hemisphere, Washington, DC.
2.
Webb, R. L., 1994, Principles of Enhanced Heat Transfer, Wiley, New York.
3.
Barthau
,
G.
,
1991
, “
Active Nucleation Site Density and Pool Boiling Heat Transfer-An Experimental Study
,”
Int. J. Heat Mass Transfer
,
35
(
2
), pp.
271
278
.
4.
Pioro
,
I. L.
,
1999
, “
Experimental Evaluation of Constants for the Rohsenow Pool Boiling Correlation
,”
Int. J. Heat Mass Transfer
,
42
, pp.
2003
2013
.
5.
Hsieh
,
S. S.
, and
Weng
,
C. J.
,
1997
, “
Nucleate Pool Boiling From Coated Surfaces in Saturated R-134a and R-407c
,”
Int. J. Heat Mass Transfer
,
42
, pp.
519
532
.
6.
Hsieh
,
S. S.
, and
Hsu
,
P. T.
,
1994
, “
Nucleate Boiling Characteristics of R114, Distilled Water and R134a on Plain and Rib-Roughened Tube Geometries
,”
Int. J. Heat Mass Transfer
,
37
(
10
), pp.
1423
1432
.
7.
Erden, A. H., and Balkan, F., 1998, “Nucleate Pool Boiling Performance of Acetone-Ethanol and Methylene Chloride-Ethanol Binary Mixtures,” IJHMA, 32(12), pp. 2403–2408.
8.
Gorenflo
,
D.
,
Gremer
,
F.
,
Danger
,
E.
, and
Luke
,
A.
,
2001
, “
Pool Boiling Heat Transfer to Binary Mixtures With Miscibility Gap: Experimental Results for a Horizontal Copper Tube With 4.35 mm O.D
,”
Exp. Therm. Fluid Sci.
,
25
, pp.
243
254
.
9.
Memory
,
S. B.
,
Sugiyama
,
D. C.
, and
Marto
,
P. J.
,
1995
, “
Nucleate Pool Boiling of R-114 and R114-oil Mixtures From Smooth and Enhanced Surfaces-I. Single Tubes
,”
Int. J. Heat Mass Transfer
,
38
, pp.
1347
1361
.
10.
Cieslinski
,
J. T.
,
2002
, “
Nucleate Pool Boiling on Porous Metallic Coatings
,”
Exp. Therm. Fluid Sci.
,
25
, pp.
557
564
.
11.
Vittala
,
C. B. V.
,
Gupta
,
S. C.
, and
Agarwal
,
V. K.
,
2001
, “
Boiling Heat Transfer From a PTFE Coated Heating Tube to Alcohols
,”
Exp. Therm. Fluid Sci.
,
25
, pp.
125
130
.
12.
Chang
,
J. Y.
, and
You
,
S. M.
,
1997
, “
Enhanced Boiling Heat Transfer From Micro-Porous Cylindrical Surfaces in Saturated FC 87 and R123
,”
ASME J. Heat Transfer
,
119
, pp.
319
325
.
13.
Kang
,
M. G.
,
2000
, “
Effect of Tube Inclination on Pool Boiling Heat Transfer
,”
ASME J. Heat Transfer
,
122
, pp.
188
192
.
14.
Cornwell
,
K.
, and
Houston
,
S. D.
,
1994
, “
Nucleate Pool Boiling on Horizontal Tubes: A Convection-Based Correlation
,”
Int. J. Heat Mass Transfer
,
37
, Suppl. 1, pp.
303
309
.
15.
Stephan
,
K.
, and
Abdelsalam
,
M.
,
1980
, “
Heat Transfer Correlations for Natural Convection Boiling
,”
Int. J. Heat Mass Transfer
,
23
, pp.
73
87
.
16.
Martin
,
T. J.
, and
Dulkravich
,
G. S.
,
1998
, “
Inverse Determination of Steady Heat Convection Coefficient Distributions
,”
ASME J. Heat Transfer
,
120
, pp.
328
334
.
17.
Maillet
,
D.
,
Degiovanni
,
A.
, and
Pasquetti
,
R.
,
1991
, “
Inverse Heat Conduction Applied to the Measurement of Heat Transfer Coefficient on a Cylinder: Comparison Between an Analytical and a Boundary Element Technique
,”
ASME J. Heat Transfer
,
113
, pp.
549
557
.
18.
Lin
,
J. H.
,
Chen
,
C. K.
, and
Yang
,
Y. T.
,
2000
, “
The Inverse Estimation of the Thermal Boundary Behavior of a Heated Cylinder Normal to a Laminar Air Stream
,”
Int. J. Heat Mass Transfer
,
43
, pp.
3991
4001
.
19.
Hantasiriwan
,
S.
,
2000
, “
Inverse Determination of Steady-State Heat Transfer Coefficient
,”
Int. Commun. Heat Mass Transfer
,
27
(
8
), pp.
1155
1164
.
20.
Aboukhachfe
,
R.
, and
Jarny
,
Y.
,
2001
, “
Determination of Heat Sources and Heat Transfer Coefficient for Two-Dimensional Heat Flow—Numerical and Experimental Study
,”
Int. J. Heat Mass Transfer
,
44
, pp.
1309
1322
.
21.
Chen
,
H. T.
,
Lin
,
S. Y.
, and
Fang
,
L. Ch.
,
2001
, “
Estimation of Surface Temperature in Two-Dimensional Inverse Heat Conduction Problems
,”
Int. J. Heat Mass Transfer
,
44
, pp.
1455
1463
.
22.
Alifanov, O. M., Artyukhin, E. A., and Rumyantsev, S. V., 1995, Extreme Methods for Solving Ill-Posed Problems With Applications to Inverse Heat Transfer Problems, Begell House, NY.
23.
Blanc, G., Raynaud, M., and Bardon, T. H., 1998, “A Guide for the Use of the Function Specification Method for 2D Inverse Heat Conduction Problem,” Revue Ge´ne´rale de la thermique, 37, pp. 17–25.
24.
Loulou, T., Artyukhin, E. A., and Bardon, J. P., 1996, “Estimation of the Time Dependent Thermal Contact Resistance at the Mold-Casting Interface,” The 2th Int. Conf. On Inverse Problems in Eng., Le Croisic, France.
25.
Holman, J. P., 1986, Heat Transfer, Mc Graw Hill Book Company.
26.
Khan, M., 1995, “Ame´lioration des e´changes thermiques en e´bullition nucle´e´e de fluides frigorige`nes sur des cylindres horizontaux et me´thode optique de mesure des caracte´ristiques ge´ome´triques d’un film liquide,” The`se de Doctorat, Universite´ de Franche Comte´.
27.
Louahlia-Gualous, H., Artyukhin, E. A., and Panday, P. K., 2002, “The Inverse Estimation of the Local Thermal Boundary Conditions in Two-Dimensional Heated Cylinder,” 4th Int. Conference on Inverse Problems in Engineering, Brazil.
28.
Parken
,
W. H.
,
Fletcher
,
L. S.
,
Sernas
,
V.
, and
Han
,
J. C.
,
1990
, “
Heat Transfer Through Falling Film Evaporation and Boiling on Horizontal Tubes
,”
ASME J. Heat Transfer
,
112
, pp.
744
750
.
You do not currently have access to this content.