Abstract

A novel hysteresis phenomenon during the transition to and back from the reverse thrust mode in a variable pitch fan (VPF) is identified and characterized in this work. This is done using a three-dimensional fully transient unsteady Reynolds-averaged Navier–Stokes (URANS) with the transitioning fan blade airfoils simulated by an adaptation of the mesh displacement method. A “real-time” simulation of the complete VPF hysteresis loop is achieved by specifying a blade wall motion through an Eulerian rotation matrix in differential, gradual steps, and is combined with a mesh probe-and-update routine for improved numerical accuracy and stability. The VPF is modeled to be transitioning in a modern 40000 lbf geared high bypass ratio turbofan engine architecture at “Approach Idle” engine power setting in a typical twin-engine airframe with the flaps, slats, and spoilers set for an aircraft touchdown airspeed of 140 knots. The transition to reverse thrust mode involves flow starvation into the engine, formation of recirculation zones in the bypass duct and the establishment of the reverse stream, all of which occurs in the opposing presence of the freestream flow at aircraft touchdown velocity. The transition back to forward flow mode involves the gradual reestablishment of the freestream, which is opposed by the presence of the reverse stream within the engine. It is quantified that in the transition to reverse thrust, the blockage develops with a larger time delay than the disappearance of the blockage during the transition back due to the interplay of the temporal dynamics of fan blade motion and flow field response. The details of the changes in the flow field behavior, the effect of engine power setting and aircraft touch-down velocity on the hysteresis behavior are explained in detail in the paper. Additional manifestations of the hysteresis phenomena at reverse thrust involving engine spool-up and down, and aircraft acceleration-deceleration maneuvers are also explored. The hysteresis phenomena described in this work are critical in properly developing control schedules to adapt for potential bistable flow field development during the landing run. The study addresses another part of the puzzle in exploring the feasibility of reverse thrust capable VPF engines for future sustainable aircraft to reach aviation climate neutrality.

References

1.
Mazzawy
,
R. S.
,
2010
, “
Performance Study for the Benefits of a Variable Pitch Composite Fan
,”
ASME
Paper No. GT2010-22148.10.1115/GT2010-22148
2.
Krishnan
,
G.
,
Perullo
,
C.
, and
Mavris
,
D. N.
,
2013
, “
An Assessment of Relative Technology Benefits of a Variable Pitch Fan and Variable Area Nozzle
,”
AIAA
Paper No. 2013-3604.10.2514/6.2013-3604
3.
Denning
,
R. M.
,
1972
, “
Variable Pitch Ducted Fans for STOL Transport Aircraft
,”
ASME
Paper No. 72-GT-61.10.1115/72-GT-61
4.
Halliwell
,
I.
, and
Justice
,
K.
,
2012
, “
Fuel Burn Benefits of a Variable-Pitch Geared Fan Engine
,”
AIAA
Paper No. 2012-3912.10.2514/6.2012-3912
5.
McKay
,
B.
, and
Barlow
,
A.
,
2012
, “
The Ultrafan Engine and Aircraft Based Thrust Reversing
,”
AIAA
Paper No. 2012-3919.10.2514/6.2012-3919
6.
Levin
,
K.
,
Rich
,
D.
,
Ross
,
K.
,
Fransen
,
T.
, and
Elliott
,
C.
,
2022
, “
Designing and Communicating Net-Zero Targets
,” World Resources Institute, Bedford, UK, accessed Nov. 30, 2023, https://www.wri.org/research/designing-and-communicating-net-zero-targets
7.
Moore
,
R. D.
,
Lewis
,
G. W.
, Jr.
, and
Tysl
,
E. R.
,
1976
, “
Performance of a Low-Pressure Fan Stage With Reverse Flow
,” National Aeronautics and Space Administration, Washington, DC, Report No.
NASA-TM-X-3349
.https://ntrs.nasa.gov/api/citations/19760009936/downloads/19760009936.pdf
8.
Engineering, Advanced and Department, Technology Programs
,
1975
, “
Quiet Clean Short-Haul Experimental Engine (QCSEE) Design Rationale
,”
National Aeronautics and Space Administration, Scientific and Technical Information Branch
,
Washington, DC
, Report No.
NASA CR-134842
.https://ntrs.nasa.gov/citations/19750056441
9.
Giffin
,
R. G.
,
McFalls
,
R. A.
, and
Beacher
,
B. F.
,
1977
, “
Quiet Clean Short-Haul Experimental Engine (QCSEE) Design Rationale. aerodynamic and Aeromechanical Performance of a 50.8 cm (20 Inch) Diameter 1.34 pr Variable Pitch Fan With Core Flow
,”
National Aeronautics and Space Administration, Scientific and Technical Information Branch
,
Washington, DC
, Report No.
NASA-CR135017
.https://typeset.io/pdf/quiet-clean-short-haul-experimental-engine-qcsee-aerodynamic-12z2i37rdm.pdf
10.
Levintan
,
R. M.
,
1975
, “
Q-Fan Demonstrator Engine
,”
J. Aircr.
,
12
(
8
), pp.
658
663
.10.2514/3.59852
11.
Williams
,
T. S.
, and
Hall
,
C. A.
,
2019
, “
Reverse Thrust Aerodynamics of Variable Pitch Fans
,”
ASME J. Turbomach.
,
141
(
8
), p.
081008
.10.1115/1.4043139
12.
Rajendran
,
D. J.
, and
Pachidis
,
V.
,
2019
, “
Fan Flow Field in an Installed Variable Pitch Fan Operating in Reverse Thrust for a Range of Aircraft Landing Speeds
,”
ASME J. Eng. Gas Turbines Power
,
141
(
10
), p.
101018
.10.1115/1.4044686
13.
Rajendran
,
D. J.
, and
Pachidis
,
V.
,
2021
, “
On the Use of an Inflatable Rubber Lip to Improve the Reverse Thrust Flow Field in a Variable Pitch Fan
,”
ASME J. Eng. Gas Turbines Power
,
143
(
11
), p.
111019
.10.1115/1.4051961
14.
Rajendran
,
D. J.
,
Tunstall
,
R.
, and
Pachidis
,
V.
,
2021
, “
Flow Distortion Into the Core Engine for an Installed Variable Pitch Fan in Reverse Thrust Mode
,”
ASME J. Turbomach.
,
143
(
7
), p.
071001
.10.1115/1.4050331
15.
Rajendran
,
D. J.
,
Tunstall
,
R.
, and
Pachidis
,
V.
,
2022
, “
Estimation of Resultant Airframe Forces for a Variable Pitch Fan Operating in Reverse Thrust Mode
,”
ASME J. Eng. Gas Turbines Power
,
144
(
12
), p.
121017
.10.1115/1.4055489
16.
Vitlaris
,
D.
,
Rajendran
,
D. J.
,
Pachidis
,
V.
,
Tunstall
,
R.
, and
Whurr
,
J.
,
2024
, “
On the Flow Physics During the Transition of a Variable Pitch Fan From Nominal Operation to Reverse Thrust Mode
,”
ASME J. Eng. Gas Turbines Power
,
146
(
4
), p.
041001
.10.1115/1.4063900
17.
Rumsey
,
C. L.
, and
Slotnick
,
J. P.
,
2015
, “
Overview and Summary of the Second AIAA High-Lift Prediction Workshop
,”
J. Aircr.
,
52
(
4
), pp.
1006
1025
.10.2514/1.C032864
18.
Rumsey
,
C. L.
,
2013
, “
The 2nd AIAA CFD High Lift Prediction Workshop (HiLiftPW-2)
,” National Aeronautics and Space Administration, San Diego, CA, accessed Nov. 29, 2023, https://hiliftpw.larc.nasa.gov/index-workshop2.html
19.
Hobbs
,
D. E.
,
Neubert
,
R. J.
,
Malmborg
,
E. W.
,
Philbrick
,
D. H.
, and
Spear
,
D. A.
,
1995
, “
Low Noise Research Fan Stage Design
,”
National Aeronautics and Space Administration, Scientific and Technical Information Branch
,
Washington, DC
, Report No.
NASA-CR-195382
.https://ntrs.nasa.gov/api/citations/19990095609/downloads/19990095609.pdf
20.
Roache
,
P. J.
,
Ghia
,
K. N.
, and
White
,
F. M.
,
1986
, “
Editorial Policy Statement on the Control of Numerical Accuracy
,”
ASME J. Fluids Eng.
, 108(1), p.
2
.10.1115/1.3242537
21.
Claus
,
R. W.
,
Evans
,
A. L.
,
Lylte
,
J. K.
, and
Nichols
,
L. D.
,
1991
, “
Numerical Propulsion System Simulation
,”
Comput. Syst. Eng.
,
2
(
4
), pp.
357
364
.10.1016/0956-0521(91)90003-N
22.
SAE International Information Report
,
2017
, “
Inlet Total-Pressure-Distortion Considerations for Gas-Turbine Engines
,” SAE Standard No. AIR1419D. 10.4271/AIR1419C
You do not currently have access to this content.