The effects of moisture on the performance of thermoelectric air conditioning systems and heat pumps equipped with a heat exchanger were studied. Coefficients of performance and fluid temperature variations were calculated for heat capacity ratios from 1 to 10 and relative humidities ranging from 0 to 100 percent at the cold fluid inlet. Only the energy effects of the water condensation are considered as it is assumed that the heat transfer coefficients are those of a dry heat exchanger. It was found that different flow arrangements and the energy associated with condensation on the cold fluid side have no strong effects on the variation of the hot fluid temperature. The coefficient of performance decreases and the cold fluid exit temperature increases when condensation occurs. When the moisture content at the cold fluid inlet increases most of the cases studied show a decrease in the difference between the optimum and uniform current results. The difference among different flow arrangements also becomes smaller as more water vapor condenses in the cold flow.

Issue Section:
Research Papers
Topics:
Air conditioners, Heat exchangers, Heat pumps, Latent heat, Fluids, Condensation, Flow (Dynamics), Temperature, Air conditioning, Heat capacity, Heat transfer coefficients, Water, Water vapor
1.
Anderson
J. R.
,
1962
, “
Thermoelectric Air Conditioner for Submarines
,”
Advanced Energy Conversion
, Vol.
2
, pp.
241
–
248
.
2.
ASHRAE Handbook of Fundamentals, 1977, American Society of Heating, Refrigerating and Air Conditioning Engineers, Inc., Atlanta, GA.
3.
Blankenship, W., Rose, C. M., and Zemanick, P., 1989, “Applications of Thermoelectric Technology to Naval Submarine Cooling,” Proceedings of the Eighth International Conference on Thermoelectric Energy Conversion, Nancy, France, pp. 224–231.
4.
Buffet, J., 1992, “A Comparative Study of Flow Optimization for TE Units and Surface Heat Exchangers,” Proceedings of the Eleventh International Conference on Thermoelectrics, University of Texas at Arlington, TX, October 7–9 pp. 155–159.
5.
Buffet, J. P., and Stockholm, J. G., 1981, “Transient Response of a Railroad Driver’s Cab Cooled by a Thermoelectric Heat Pump,” Proceedings of the Sixteenth Intersociety Energy Conversion Engineering Conference, Atlanta, GA, pp. 2022–2088.
6.
Cengel, Y. A., and Boles, M. A., 1994, Thermodynamics: An Engineering Approach, Second Edition, McGraw-Hill, New York, NY, pp. 399, 923.
7.
Chen
K.
, and
Gwilliam
S. B.
,
1994
, “
Optimal Design of TE Air Conditioning Systems with Difference Flow Arrangements
,”
Optimum Design of Thermal Systems and Components
, ASME HTD-Vol.
279
, pp.
11
–
18
.
8.
Chen
K.
, and
Gwilliam
S. B.
,
1996
, “
An Analysis of the Heat Transfer Rate and Efficiency of TE (Thermoelectric) Cooling Systems
,”
International Journal of Energy Research
, Vol.
20
, pp.
399
–
417
.
9.
Frank, L. E., 1984, “Optimization Techniques for TE (Peltier) Counter-Flow Heat Exchangers,” Proceedings of the Fifth International Conference on Thermoelectric Energy Conversion, Arlington, TX, Mar., pp. 102–108.
10.
Goldsmid, H. J., 1964, Thermoelectric Refrigeration, Plenum Press, New York, NY, pp. 210–223.
11.
Gwilliam, S. B., 1991, “Feasibility and Prototype Development of a TE Cooler for Parked Aircraft,” Proceedings of the Tenth International Conference on Thermoelectrics, Cardiff, U.K., Sept., pp. 218–221.
12.
Gwilliam, S. B., Entezam, B., and Tatton, S. C., 1992, “TE Air Conditioning Using Evaporative Cooling of Waste Heat Air for Parked Aircraft,” Proceedings of the Eleventh International Conference of Thermoelectric Energy Conversion, Arlington, TX pp. 164–174.
13.
Gwilliam, S. B., 1993, “Design and Test of a Thermoelectric Air-Conditioning System for Cooling Parked Aircraft,” MS thesis, Department of Mechanical Engineering, University of Utah, Salt Lake City, UT.
14.
Harman, T. C., and Honig, J. M., 1967, Thermoelectric and Thermomaganetic Effects and Applications, McGraw-Hill, New York, NY, pp. 276–310.
15.
Heenan, P., and Mathiprakasam, B., 1992, “Development of Two-Man TE Microclimate Conditioner for Use in Army Ground Vehicles,” Proceedings of the Eleventh International Conference on Thermoelectric Energy Conversion, Arlington, TX pp. 181–184.
16.
Highgate
D. J.
, and
Probert
S. D.
,
1990
, “
Higher Energy-Efficiency, Readily Transportable Incubators
,”
Applied Energy
, Vol.
35
, pp.
135
–
149
.
17.
Incropera, F. P., and Dewitt, D. P., Introduction to Heat Transfer, Second Edition, John Wiley & Sons, New York, NY, 1990, p. 619.
18.
Kays, W. M., and London, A. L., 1984, Compact Heat Exchangers, McGraw-Hill, New York, NY, pp. 186–213.
19.
Lindenblad
N. E.
,
1958
, “
Thermoelectric Heat Pumping
,”
Electrical Engineering
, Vol.
77
, pp.
802
–
806
.
20.
Mathiprakasam, B., and Sutikno, T., 1984, “Analytical Model for Predicting the Performance of Cross-Flow TE Liquid Coolers,” Proceedings of the Fifth International Conference on Thermoelectric Energy Conversion, Arlington, TX pp. 75–79.
21.
Mathiprakasam, B., Fiscus, D., and Glauz, W., 1986, “Performance of Cross-Flow TE Liquid Coolers,” Proceedings of the Sixth International Conference on Thermoelectric Energy Conversion, Arlington, TX pp. 69–73.
22.
Mathiprakasam, B., 1987, Methods of Obtaining Optimum Performance from a Thermoelectric Heating/Cooling Device, U.S. Patent No. 4,634,803.
23.
Mathiprakasam, B., Jones, D., Heenan, P., and Brantley, D., 1989, “Development of a 1000 Watt Thermoelectric Air Conditioner,” Proceedings of the Eighth International Conference on Thermoelectric Energy Conversion, Nancy, France pp. 232–234.
24.
McQuiston, F. C., and Parker, J. D., 1982, Heating, Ventilating, and Air Conditioning—Analysis and Design, Second Edition, John Wiley & Sons, New York, NY, pp. 603–606.
25.
MELCOR Materials Electronics Products Corporation, 1992, Product Specifications, Trenton, NJ.
26.
Rowe, D. W., and Bhandari, C. M., 1983, Modern Thermoelectrics, Reston Publishing Company, Reston, VA, pp. 1–5, 108–111.
27.
Schlicklin, P. M., and Stockholm, J. G., 1988, “Thermoelectric Modules Characterizations,” Proceedings of the Seventh International Conference on Thermoelectric Energy Conversion, Arlington, TX, pp. 65–70.
28.
Stockholm, J. G., and Buffet, J. P., 1980, “Large Gas to Gas TE heat Pumps,” Proceedings of the Third International Conference on Thermoelectric Energy Conversion, Arlington, TX pp. 120–125.
29.
Stockholm, J. G., and Pujol-Soulet, L., 1982, “Prototype Thermoelectric Air Conditioning of a Passenger Railway Coach,” Proceedings of the Fourth International Conference on Thermoelectric Energy Conversion, Arlington, TX pp. 136–141.
30.
Stockholm, J. G., and Schlicklin, P., 1988, “TE Cooling for Naval Applications,” Proceedings of the Seventh International Conference on Thermoelectric Energy Conversion, Arlington, TX pp. 79–84.
31.
Stockholm, J. G., and Schlicklin, P., 1989, “Naval Thermoelectric Cooling,” Proceedings of the Eighth International Conference on Thermoelectric Energy Conversion, Nancy, France, pp. 235–238.
32.
Stockholm, J. G., 1990, “Modern Thermoelectric Cooling Technology,” Proceedings of the Ninth International Conference on Thermoelectrics, Pasadena, CA pp. 90–108.
33.
Stockholm, J. G., and Stockholm, D. W., 1992, “TE Modeling of a Cooling Module with Heat Exchangers,” Proceedings of the Eleventh International Conference on Thermoelectric Energy Conversion, Arlington, TX, pp. 140–146.
34.
Wu
C.
, and
Schulden
W.
,
1994
, “
Specific Heating Load of Thermoelectric Heat Pumps
,”
Energy Conversion and Management
, Vol.
35
, No.
6
pp.
459
–
464
.
35.
Yamamura, A., 1976, “Computer Aided Design for TE Heat Exchanger,” Proceedings of the First International Conference on Thermoelectric Energy Conversion, Arlington, TX pp. 72–76.
This content is only available via PDF.
Copyright © 1996
 by The American Society of Mechanical Engineers
You do not currently have access to this content.