A microtubular solid oxide fuel cell (SOFC) bundle was developed based on a new design. Anode-supported microtubular SOFCs with the cell configuration, (LSCF)- (CGO) cathode/CGO electrolyte/Ni-CGO anode were fabricated and bundled in a porous LSCF current-collecting cube with sides of 1 cm. The power generation of the fabricated SOFC bundle was measured under pressurized conditions. Using humidified 30% mixture gas and air, the cubic power density of the bundle at under atmospheric pressure (0.1 MPa) was at . With increasing operating pressure, the performance increased, and the cubic power density reached at 0.6 MPa. The power enhancement brought about by pressurization was due to increased open circuit voltage and reduced polarization resistance. After comparing the power gain of the pressurized SOFC and the power consumption gain of the air compressor used for pressurization, it was found that pressurized cell operation exhibited the highest actual power gain at around 0.3 MPa.
Skip Nav Destination
Article navigation
April 2011
This article was originally published in
Journal of Fuel Cell Science and Technology
Research Papers
Power Generation Properties of Microtubular Solid Oxide Fuel Cell Bundle Under Pressurized Conditions
S. Hashimoto,
S. Hashimoto
Central Research Institute of Electric Power Industry (CRIEPI)
, 2-6-1 Nagasaka, Yokosuka, Kanagawa 240-0196, Japan
Search for other works by this author on:
Y. Liu,
Y. Liu
Central Research Institute of Electric Power Industry (CRIEPI)
, 2-6-1 Nagasaka, Yokosuka, Kanagawa 240-0196, Japan
Search for other works by this author on:
K. Asano,
K. Asano
Central Research Institute of Electric Power Industry (CRIEPI)
, 2-6-1 Nagasaka, Yokosuka, Kanagawa 240-0196, Japan
Search for other works by this author on:
F. Yoshiba,
F. Yoshiba
Central Research Institute of Electric Power Industry (CRIEPI)
, 2-6-1 Nagasaka, Yokosuka, Kanagawa 240-0196, Japan
Search for other works by this author on:
M. Mori,
M. Mori
Central Research Institute of Electric Power Industry (CRIEPI)
, 2-6-1 Nagasaka, Yokosuka, Kanagawa 240-0196, Japan
Search for other works by this author on:
Y. Funahashi,
Y. Funahashi
Fine Ceramics Research Association (FCRA),
AIST
, Shimo-shidami, Moriyama-ku, Nagoya 463-8561, Japan
Search for other works by this author on:
Y. Fujishiro
Y. Fujishiro
Advanced Industrial Science and Technology (AIST)
, Shimo-shidami, Moriyama-ku, Nagoya 463-8561, Japan
Search for other works by this author on:
S. Hashimoto
Central Research Institute of Electric Power Industry (CRIEPI)
, 2-6-1 Nagasaka, Yokosuka, Kanagawa 240-0196, Japan
Y. Liu
Central Research Institute of Electric Power Industry (CRIEPI)
, 2-6-1 Nagasaka, Yokosuka, Kanagawa 240-0196, Japan
K. Asano
Central Research Institute of Electric Power Industry (CRIEPI)
, 2-6-1 Nagasaka, Yokosuka, Kanagawa 240-0196, Japan
F. Yoshiba
Central Research Institute of Electric Power Industry (CRIEPI)
, 2-6-1 Nagasaka, Yokosuka, Kanagawa 240-0196, Japan
M. Mori
Central Research Institute of Electric Power Industry (CRIEPI)
, 2-6-1 Nagasaka, Yokosuka, Kanagawa 240-0196, Japan
Y. Funahashi
Fine Ceramics Research Association (FCRA),
AIST
, Shimo-shidami, Moriyama-ku, Nagoya 463-8561, Japan
Y. Fujishiro
Advanced Industrial Science and Technology (AIST)
, Shimo-shidami, Moriyama-ku, Nagoya 463-8561, JapanJ. Fuel Cell Sci. Technol. Apr 2011, 8(2): 021010 (6 pages)
Published Online: November 30, 2010
Article history
Received:
October 2, 2009
Revised:
June 24, 2010
Online:
November 30, 2010
Published:
November 30, 2010
Citation
Hashimoto, S., Liu, Y., Asano, K., Yoshiba, F., Mori, M., Funahashi, Y., and Fujishiro, Y. (November 30, 2010). "Power Generation Properties of Microtubular Solid Oxide Fuel Cell Bundle Under Pressurized Conditions." ASME. J. Fuel Cell Sci. Technol. April 2011; 8(2): 021010. https://doi.org/10.1115/1.4002314
Download citation file:
Get Email Alerts
Cited By
Energy Management of Hybrid Electric Vehicle Considering Battery and Fuel Cell Parameters Using Multi-Objective Optimization for Dynamic Driving Cycles
J. Electrochem. En. Conv. Stor (November 2025)
Electric Vehicles Charging Time Prediction Based on Multimodel Fusion
J. Electrochem. En. Conv. Stor (November 2025)
Analysis of Thermal Runaway Temperature Characteristics, Gas Composition, and Thermal Runaway Products of Semi-Solid Li(Ni0.6Co0.2Mn0.2)O2 Battery
J. Electrochem. En. Conv. Stor (November 2025)
Dynamic Loading for Solid Oxide Stacks Under Limited Actuation
J. Electrochem. En. Conv. Stor (November 2025)
Related Articles
Polarization Resistances of ( Ln 1 − x Sr x ) CoO 3 ( Ln = Pr , Nd, Sm, and Gd x = 0 , 0.3, 0.5, 0.7, and 1) as Cathode Materials for Intermediate Temperature-operating Solid Oxide Fuel Cells
J. Fuel Cell Sci. Technol (August,2009)
Performances and Degradation Phenomena of Solid Oxide Anode Supported Cells With LSM and LSCF Cathodes: An Experimental Assessment
J. Fuel Cell Sci. Technol (February,2009)
La 0.6 Sr 0.4 Co 0.2 Fe 0.8 O 3 – Ag Composite Cathode for Intermediate-Temperature Solid Oxide Fuel Cells
J. Fuel Cell Sci. Technol (August,2008)
Geometrical Optimization of Double Layer LSM/LSM-YSZ Cathodes by Electrochemical Impedance Spectroscopy
J. Fuel Cell Sci. Technol (February,2010)
Related Proceedings Papers
Related Chapters
The Study on Linear Component Technique in Identifying the Polarization of Electromagnetic Waves
International Conference on Computer and Electrical Engineering 4th (ICCEE 2011)
Effects of Metallic Plate and Objects on Performance of Inverted F Antenna for ISM Band Application
International Conference on Computer and Automation Engineering, 4th (ICCAE 2012)
Joint Polarization Information for Fast Multi-Target Localization in Bistatic MIMO Radar System
International Symposium on Information Engineering and Electronic Commerce, 3rd (IEEC 2011)